Because laser technology has the characteristics of low welding heat input, little influence on the welding heated area and not easy to deform, it has received special attention in the field of alumin...
Diaphragms made of plastic or rubber are very important components in vacuum pumps. Because the diaphragm must form a tight seal between the pump's inner and outer chambers for efficient pumping. The ...
It is no longer a problem for laser cutting machines to cut steel plates below 10mm thick. But if you want to cut thicker steel plates, you often resort to high-power lasers with an output power excee...
1. What is a slender shaft?Shafts whose length-to-diameter ratio is greater than 25 (ie L/D>25) are called slender shafts. Such as the screw on the lathe, the feed rod, etc.2. the processing difficult...
Conduct in-depth cooperation with more than 500 foreign buyers, and maintains long-term cooperation with more than 1,000 domestic advanced manufacturing suppliers.
English
Solutions to Three Difficulties in Aluminum Alloy Laser Welding
2023-02-15Because laser technology has the characteristics of low welding heat input, little influence on the welding heated area and not easy to deform, it has received special attention in the field of alumin...
Read MoreLaser Cut Vacuum Pump Diaphragm Solutions
2023-02-15Diaphragms made of plastic or rubber are very important components in vacuum pumps. Because the diaphragm must form a tight seal between the pump's inner and outer chambers for efficient pumping. The ...
Read MoreTechnical Difficulties and Solutions for Laser Cutting Processing of Thick Steel Plates
2023-02-15It is no longer a problem for laser cutting machines to cut steel plates below 10mm thick. But if you want to cut thicker steel plates, you often resort to high-power lasers with an output power excee...
Read MoreMachining solutions for slender shafts
2023-02-151. What is a slender shaft?Shafts whose length-to-diameter ratio is greater than 25 (ie L/D>25) are called slender shafts. Such as the screw on the lathe, the feed rod, etc.2. the processing difficult...
Read More